Friday 15 February, 2019 |

Mercedes Benz star c3: Error during initializing, no link could be established

by Administrator | post a comment

Mercedes Benz star c3: Error during initializing, no link could be established

When setup Mercedes Benz star c3, you maybe come across such fault "Error during initializing, no link could be established between the diagnosis gateway and the control unit" as the following shows.





I give you a solution that is to check whether you set right COM Port. If you buy star C3 from uobdii.com, please set the COM Port as follows.

First step: right click “my computer”, and then click “Properties”.



Step 2: Under the “System Properties”, first click “Hardware” and then click “Device Manager”.



Step 3: under Device Manager, click Communication Port (COM2), open the Communication Port (COM2) Properties, then click “Port settings”, please be sure “bits per second :115200, then click “ Advanced”, under the “ Advanced settings for COM2”, please be sure the COM Port Number is “COM2”

Step 4: your Mb star C3 is ready to work.

Gsunlight.com-- China OBD2 Tool, Automotive Diagnostic Tools, Car Key Programmer, OBD2 ECU chip tuning tool Center.

Contact information:

Website: www.gsunlight.com

Email: gsunlight@outlook.com  /  happysunlight2014@outlook.com  /  mickaltech@gmail.com

Skype: gsunlight@outlook.com  /  fionalyy88@gmail.com

Whatsapp: +86-13691674080  /  +86-13538280570  /  +86-14776192853 

News for Friday 19 October, 2018

• ODIS 4.4.10 Download Software 5 in 1 VAG Audi VW ODIS 4.4.10 Crack Software With ODIS Engineering 8.2.3 Download, ETKA 8.1, Elsawin 5.3 Ready To Use

View all news for Friday 19 October, 2018 on one page

Recent News

• Tuesday 18 September, 2018
• Friday 14 September, 2018
• Friday 07 September, 2018
• Thursday 06 September, 2018
• Friday 31 August, 2018

News archive